Pages of interest
- main
- ZD Racing Zmt-10 / Turnigy Stadium King 2wd page
- The Redcat Racing Page , broke parts list ETC.
- ZD Racing ZMR-16 / ZMR-16R /ZMB-16 / ZMC-16 / ZMC-16C (1:16 Scale)
- Products I have tried
- Low cost crawler
- Phoenix arms HP22 HP25 .22lr .25 acp info
- Clerke first 1st revolver .32 S&W .22LR Terrier o...
- Cetme C308 HK-91
- 3d printing
Monday, June 29, 2015
( 2 year plus update) Turnigy 4000mAh 2S 30C hardcase pack
Original post ( May 17, 2013 )
Well in the time I have owned 2 of these packs " a little over 2 years" I have repeatedly compared it to the ZIPPY Flightmax 4000mAh 2S1P 25C Car Lipoly which is one of the cheapest hard-case packs on the market . To be fair they have both aged about the same. Both originally had usable capacities of around 4000 Mah and both are running around 2200 Mah these days when ran in my ZD Racing ZMT 10 and in less demanding applications "crawler and slower vintage cars and trucks " I see usable capacities around 3500 Mah. I will say these packs seem to require being balanced more often than the 4000 Mah zippy packs . I also had a physical failure recently . It seems the positive lead broke the tab that is used to attach it to the cell and so the pack is dead as I'm not going to even attempt fixing it . I do think this could have been prevented if I had forced some silicone sealant into the case around the wires to give them additional support . But in short I feel I got lots of good use and bang for my buck with these packs and if you can't run the 4000 Mah Zippy packs due to your chassis design I feel Turnigy should be the next pack to check out .
Sunday, June 28, 2015
(2 year plus update) ZIPPY Flightmax 4000mAh 2S1P 25C Car Lipoly (ROAR APPROVED)
Original post ( June 15, 2013 )
After 2 years I'm happy to say. I have had a great experience with these batteries and for the money they have been a great battery .
Originally I purchased 2 of these and they have both been comparable and aged equally in terms of usable capacity and punch .
Usable capacity has dropped off as time has gone on and they are both down to about 2200 Mah worth of usable capacity when ran in my ZD Racing zmt 10 compared to ruffly 4000 Mah usable capacity when they where new . The primary difference is the voltage sag during use . Basically the LVC of the speed controller will get tripped much earlier due to the dip in voltage . Without a load the battery will read around 6.84 volts but with a load applied a 6.2 volt LVC will trip. So these batteries are now being used primarily in slower and less amp hungry applications where they still preform quite well and when matched with the right application " crawlers and low powered vintage stuff "can still provide about 3500 Mah . The packs still maintain there balance well no matter the rate they are discharged at and still do not require balance charging often .
So if your chassis design will allow you to use these packs I consider these my top pick for low cost and effective Lipo's.
After 2 years I'm happy to say. I have had a great experience with these batteries and for the money they have been a great battery .
Originally I purchased 2 of these and they have both been comparable and aged equally in terms of usable capacity and punch .
Usable capacity has dropped off as time has gone on and they are both down to about 2200 Mah worth of usable capacity when ran in my ZD Racing zmt 10 compared to ruffly 4000 Mah usable capacity when they where new . The primary difference is the voltage sag during use . Basically the LVC of the speed controller will get tripped much earlier due to the dip in voltage . Without a load the battery will read around 6.84 volts but with a load applied a 6.2 volt LVC will trip. So these batteries are now being used primarily in slower and less amp hungry applications where they still preform quite well and when matched with the right application " crawlers and low powered vintage stuff "can still provide about 3500 Mah . The packs still maintain there balance well no matter the rate they are discharged at and still do not require balance charging often .
So if your chassis design will allow you to use these packs I consider these my top pick for low cost and effective Lipo's.
Sunday, June 21, 2015
Been a while .
Well I haven't posted anything for along time but that's about to change .
Tuesday, September 23, 2014
New Redcat Racing R.C.'s just in time for Christmas
As disappointing as it is that Redcat Racing is currently not selling the Terremoto 1/8th scale monster truck and hasn't been able to ship any of the Terremoto-10 's out to market due to some issues . The company is steam rolling right on ahead with a few new additions jointing there lineup just in time for christmas .
First and for most the Blackout XTE that will be available in both brushed and brushless versions .
This Truck isn't as huge as the Terremoto-10 but falls right in line with the majority of 1/10th scale Monster trucks out there . Best I can figure this truck was originally meant to be sold as the Terremoto-10 's cheaper little brother and I think it is meant to replace both the volcano and the caldera lineups as its MSRP. undercuts both lines .
Brushless price compare:
http://www.redcatracing.com/Blackout-XTE-PRO
MSRP. $229.99
http://www.redcatracing.com/Volcano-EPX-PRO
MSRP. $249.99
http://www.redcatracing.com/CALDERA-10E_3
MSRP. $259.99
Brushed price compare :
http://www.redcatracing.com/Blackout-XTE
MSRP. $149.99
http://www.redcatracing.com/Volcano-EPX
MSRP. $159.99
Now as far as features design etc. this truck doesn't really break any molds and I don't see it setting the world on fire but what I do think its going to be is a reliable platform and a exceptional value . By the way Redcat is including a 3200 Mah lipo battery and a basic lipo charger with the brushless version just to up the ante a bit .
I have also changed the compation to the Terremoto-10 to include the Blackout XTE.
Now on to the 2 other soon to be released trucks .
The Everest-10 and Everest 1/16th scale Rock crawlers .
http://www.redcatracing.com/EVEREST-10
http://www.redcatracing.com/Everest-16
Now These Crawlers May look familiar to you as they did to me . The OEM manufacture is HSP and they have a couple of variations of these crawlers being sold under various Brand names . The most notable name these are sold under is the Maxstone name . They are generally regarded as very good crawlers for first time buyers .
First and for most the Blackout XTE that will be available in both brushed and brushless versions .
This Truck isn't as huge as the Terremoto-10 but falls right in line with the majority of 1/10th scale Monster trucks out there . Best I can figure this truck was originally meant to be sold as the Terremoto-10 's cheaper little brother and I think it is meant to replace both the volcano and the caldera lineups as its MSRP. undercuts both lines .
Brushless price compare:
http://www.redcatracing.com/Blackout-XTE-PRO
MSRP. $229.99
http://www.redcatracing.com/Volcano-EPX-PRO
MSRP. $249.99
http://www.redcatracing.com/CALDERA-10E_3
MSRP. $259.99
Brushed price compare :
http://www.redcatracing.com/Blackout-XTE
MSRP. $149.99
http://www.redcatracing.com/Volcano-EPX
MSRP. $159.99
Now as far as features design etc. this truck doesn't really break any molds and I don't see it setting the world on fire but what I do think its going to be is a reliable platform and a exceptional value . By the way Redcat is including a 3200 Mah lipo battery and a basic lipo charger with the brushless version just to up the ante a bit .
I have also changed the compation to the Terremoto-10 to include the Blackout XTE.
Now on to the 2 other soon to be released trucks .
The Everest-10 and Everest 1/16th scale Rock crawlers .
http://www.redcatracing.com/EVEREST-10
http://www.redcatracing.com/Everest-16
Now These Crawlers May look familiar to you as they did to me . The OEM manufacture is HSP and they have a couple of variations of these crawlers being sold under various Brand names . The most notable name these are sold under is the Maxstone name . They are generally regarded as very good crawlers for first time buyers .
I just want to build a mini monster truck with one :-)
Subscribe to:
Posts (Atom)